TZ Stromag, Filiale Fiesch
3984 Fiesch · about 75.4 km
TZ Stromag is a full-service provider of electrical engineering, specializing in installations, telematics, automation, and switchgear construction.
stromag.chSolar panels · Küssnacht (SZ)

At a glance
Small project
CHF 8'700 – CHF 16'400
Typical project
CHF 16'000 – CHF 29'000
Large project
CHF 27'700 – CHF 49'200
| Project | Quantity | Low | High | Per unit |
|---|---|---|---|---|
| Small project | 5 kWc | CHF 8'700 | CHF 16'400 | CHF 2'400 |
| Typical project | 10 kWc | CHF 16'000 | CHF 29'000 | CHF 2'200 |
| Large project | 18 kWc | CHF 27'700 | CHF 49'200 | CHF 2'100 |
Computed with our estimator for Küssnacht (SZ) (regional factor included), standard finish. Only the project size changes.
Included
Not included
In Küssnacht (SZ), the federal building register lists 2'217 residential buildings and 6'592 dwellings. These municipal benchmarks help put your home in context, but do not replace an individual assessment.
47 % built before 1980
Construction year does not reveal past renovations: check the current insulation condition.
42 % · Heat pump
This distribution describes recorded buildings, not your system's consumption or efficiency.
| Energy | Heating | Hot water |
|---|---|---|
| Gas | 3 % | 3 % |
| Heating oil | 32 % | 31.6 % |
| District heating | 7 % | 6.3 % |
| Heat pump | 42 % | 14 % |
| Electricity | 7 % | 34 % |
| Wood | 9 % | 6.4 % |
| Solar thermal | 0 % | 4.2 % |
Each line gives the share of buildings using that energy, separately for heating and for hot water. The two columns do not always reach 100%: some buildings combine two systems, or reported none.
A standard non-condensing boiler is usually older and less efficient.
14.7 % of buildings mix housing with shops or offices.
For your renovation plans in Küssnacht, RegBL data provides helpful benchmarks, although coverage remains partial. Regarding building scale, there is a median volume of 1395.5 m3 for the 10 houses measured according to the SIA 416 standard, which is essential for estimating the scope of heating and insulation upgrades. Data concerning specific renovation years or heritage protection status is not recorded. Given these gaps in coverage, we strongly advise homeowners to contact the local municipal authorities early in the planning process to verify any specific building requirements or historical conservation constraints that might apply to your individual property.
Source : OFS — RegBL (export communal complet). Existing residential buildings; percentages of recorded values.
Profitability depends mainly on how much power you use on site. By maximizing your self-consumption, you reduce your grid dependence and lower your energy bills in the long run.
It is advisable to adapt your consumption habits, such as using large appliances during sunny hours, to make the most of your initial investment. Careful planning with a local expert will help you size your system according to your actual needs.
To get a precise price range, use our free RenoIndex estimator now to plan your total budget with peace of mind.
In addition to this support, check if tax deductions are possible at the cantonal or federal level. Combining these aids can accelerate the return on investment.
Use the free RenoIndex estimator to get a price range in CHF and understand the financial impact of your project in the Küssnacht area.
However, it is always recommended to check with your municipality to see if there are any restrictions related to protected areas or the local landscape. Good administrative preparation helps avoid delays in putting your panels into operation.
RenoIndex supports you by providing advice on planning costs, allowing you to calmly anticipate each technical and administrative step of the process.
Opting for solar power in Küssnacht is a sustainable choice that adds value to your real estate assets. In addition to ecological benefits, you benefit from increased independence from energy market fluctuations.
The development of storage technologies now allows for storing excess energy for nighttime use, thereby increasing your overall energy efficiency. By investing today, you actively participate in the Swiss energy transition while achieving substantial savings.
To accurately estimate the cost of such an installation on your roof, do not hesitate to consult our free RenoIndex estimator and discover the approximate amount in CHF.
1. Estimate
Set a budget range with the estimator.
2. Grants
Apply before work starts.
3. Quotes
Compare at least 3 quotes.
4. Permit
Check with the municipality whether a permit is needed.
5. Works
Follow the site and do a written handover.
No specific grant listed for this work. Maintenance tax deductions may still apply.
3984 Fiesch · about 75.4 km
TZ Stromag is a full-service provider of electrical engineering, specializing in installations, telematics, automation, and switchgear construction.
stromag.ch2832 Rebeuvelier · about 82.1 km
Eco6therm specializes in the installation of heating systems, particularly heat pumps, and solar photovoltaic energy solutions.
eco6therm.ch2740 Moutier · about 85 km
Company in Moutier specializing in plumbing, heating (oil, wood, heat pumps), and solar thermal and photovoltaic solutions.
bmonnerat.ch2740 Moutier · about 85 km
Moutier-based company specializing in tinsmithing, roofing, ventilated facades, and solar panel installation.
zbinden-joye.chSuggestions from the commercial register by distance and activity. Not an endorsement or partnership.
In most cases, a solar installation integrated into the roof is only subject to a notification procedure. However, check the specific rules of your municipality, especially if your building is listed or located in a protected area.
The main support is the federal one-off remuneration via Pronovo. It subsidizes part of the investment costs for small photovoltaic systems. It is essential to apply before starting the work.
The cost depends on the roof area, power, and complexity. To get a realistic price range in CHF, you can use our free RenoIndex estimator, which takes your specific needs into account.
Profitability depends heavily on your self-consumption rate. The more you use the electricity you produce at the time you generate it, the faster your investment will be amortized. A proper sizing study is recommended.